Kawasaki Ninja 300 Rearsets and Engine Protection

After the experience gained in the European SS 300 with the Yamaha R3, Extreme Components is proud to present the rearsets and engine protections for the Kawasaki Ninja 300.
Both of these products are entirely machined by CNC and the rearsets are mounted on bearings housed in special steel bushes to prevent the dawdle which would be created if processed directly on the aluminum. Studied by solidworks for the calculation of controlled deformations and predetermined break points, ensure a perfect push sensitivity due to their stiffness and at the same time do not affect the protection of the frame in case of fall.
The heels are made of carbon processed in autoclave and cut with water jet.
The engine protection always protect the crankshaft thanks to the slider built-in structure in the most critical areas of impact with the ground. The bolts that are drowned in special limescales discharge the traction forces in case of contact with an obstacle and facilitate the replacement as they are protected and are not affected by the disassembly of the ones caused by any asphalt rubbing wear.

Available now
Extreme Components

Sign up for our newsletter

This website uses third party technical cookies to guarantee a better navigation service throughout the website. For further information on how to select or refuse the cookies, please read our Cookie Policy.
Clicking the “accept” botton you will allow the use of third-party cookies. View e-Privacy Directive Documents - View GDPR Documents
Read the Privacy and Cookie policy Accept Decline